Make Your Own Baby Ring Sling

A baby ring sling is a type of carrier that allows you to wear your baby close to your body in a variety of positions. It consists of a long piece of fabric that is threaded through two metal rings and wrapped around your shoulder and torso. Baby ring slings are convenient, comfortable, and versatile. They can be used from newborn to toddler stage, and they can help you bond with your baby, breastfeed discreetly, and free up your hands for other tasks.-

 

One of the advantages of baby ring slings is that they are easy to make at home. You don't need any sewing skills or special equipment. All you need is some fabric, two rings, scissors, and a measuring tape. Here are the steps to make your own baby ring sling:-

 

1. Choose your fabric. You want a fabric that is strong, breathable, and soft. Some good options are cotton, linen, or bamboo. Avoid fabrics that are too stretchy, slippery, or heavy. You can use a single color or a pattern that you like. You will need about 2 to 2.5 meters (6 to 8 feet) of fabric, depending on your height and preference.-

 

2. Choose your rings. You want rings that are specifically designed for baby slings, as they are tested for safety and durability. They should be made of metal, such as aluminum or stainless steel, and have no gaps or welds. They should be about 5 to 7 cm (2 to 3 inches) in diameter. You can find them online or in some craft stores. You can choose a color that matches or contrasts with your fabric.-

 

3. Cut your fabric. Lay your fabric flat on the floor or a large table. Cut it into a long rectangle that is about 75 cm (30 inches) wide and 2 to 2.5 meters (6 to 8 feet) long. You can trim the edges if they are uneven or frayed.-

 

4. Thread your fabric through the rings. Fold your fabric in half lengthwise, with the wrong side facing out. Find the middle point of the folded edge and mark it with a pin or a safety pin. Take one end of the fabric and thread it through both rings from below. Then bring it back over the top ring and under the bottom ring, creating a loop. Pull the fabric until the middle point is aligned with the rings.-

 

5. Adjust your sling. Put the rings over one shoulder and spread the fabric across your back and under your opposite arm. The rings should be at a comfortable height on your chest, about where you would wear a corsage or a brooch. The fabric should be snug but not too tight around your body. You can adjust the length by pulling more or less fabric through the rings.-

 

6. Wear your baby in the sling. To wear your baby in the sling, hold them close to your chest and slide them into the pouch created by the fabric. Make sure their head is supported by the fabric or by your hand. You can position them facing you, facing outwards, on your hip, or on your back, depending on their age and preference. Always check that their airway is clear and that they are secure in the sling.-